Mechanical and Shape Memory Properties of Poly(vinyl acetate)/Poly(lactic acid) Blends

Document Type : Research Paper

Authors

1 Department of Chemical Engineering, Faculty of Engineering, University of Maragheh, P.O.Box: 55181-83111, Maragheh, Iran

2 Department of Plastics, Iran Polymer and Petrochemical Institute (IPPI), Tehran P.O.Box: 14975-112, Iran

Abstract

Hypothesis: Shape memory polymers (SMPs) are intelligent materials that can be set into temporary shape and return to their permanent (original) shape when an external stimulus is applied. Poly(vinyl acetate) (PVAc) is a low cost biopolymer. However, its use in biomedical applications, especially as an SMP, is limited due to its low modulus and strength. On the other hand, poly(lactic acid) (PLA) is a biodegradable polymer with robust structure. Hence, blending of these two polymers can improve mechanical properties as well as shape memory behavior of PVAc.
Methods: a series of shape memory materials were prepared through blending of PVAc and PLA through solution mixing method using chloroform as solvent.
Findings: Microstructure of the prepared samples studied by X-ray diffraction spectroscopy (XRD) and atomic force microscopy (AFM), indicated that the components of the blends were favorably compatible. Moreover, dynamic mechanical thermal analysis (DMTA) and tensile test showed that the blending of these compatible biopolymers led to improvement in tensile strength and modulus of PVAc. Finally, the shape memory experiments revealed that the PVAc/PLA blends exhibited improved shape memory behavior as compared with their parent polymers. For instance, by incorporation of 30 wt% PLA into PVAc, the shape recovery increased from 75.4 to 91.5%. The improvement in the shape recovery was assigned to higher stored elastic energy in the blends as compared with that in neat polymers, which provided a larger driving force for corresponding quick and almost complete shape recovery. This procedure may open an avenue to fabricate SMPs through a simple blending method to be applied in different biomedical areas.

Keywords

References

1. Zhao Q., Qi H.J., and Xie T., Recent Progress in Shape Memory Polymer: New Behavior, Enabling Materials, and Mechanistic Understanding, Prog. Polym. Sci., 49, 79-120, 2015.
2.Hornbogen E., Review Thermo-mechanical Fatigue of Shape Memory Alloys, J. Mater. Sci., 39, 385-399, 2004.
3.Yuan D., Chen Z., Xu C., Chen K., and Chen Y., Fully Biobased Shape Memory Material Based on Novel Cocontinuous Structure in Poly(lactic acid)/Natural Rubber TPVs Fabricated via Peroxide-Induced Dynamic Vulcanization and in Situ Interfacial Compatibilization, ACS Sustainable Chem. Eng., 3, 2856-2865, 2015.
4.Meng Q. and Hu J., A Review of Shape Memory Polymer Composites and Blends, Composites, Part A, 40, 1661-1672, 2009.
5.Xie T., Xiao X., and Cheng Y.T., Revealing Triple-Shape Memory Effect by Polymer Bilayers, Macromol. Rapid Commun., 30, 1823-7, 2009.
6.Chen L., Li W., Liu Y., and Leng J., Nanocomposites of Epoxy-based Shape Memory Polymer and Thermally Reduced Graphite Oxide: Mechanical, Thermal and Shape Memory Characterizations, Composites, Part B, 91, 75-82, 2016.
7.Jeong H.M., Ahn B.K., and Kim B.K., Miscibility and Shape Memory Effect of Thermoplastic Polyurethane Blends with Phenoxy Resin, Eur. Polym. J., 37, 2245-2252, 2001.
8.Lashgari S., Karrabi M., Ghasemi I., Azizi H., Messori M., and Paderni K., Shape Memory Nanocomposite of Poly(L-lactic acid)/Graphene Nanoplatelets Triggered by Infrared Light and Thermal Heating, eXPRESS Polym. Lett., 10, 349-359, 2016.
9.Keramati M., Ghasemi I., Karrabi M., Azizi H., and Sabzi M., Incorporation of Surface Modified Graphene Nanoplatelets for Development of Shape Memory PLA Nanocomposite, Fibers Polym., 17, 1062-1068, 2016.
10.Alfayyadh A.A., Lotfy S., Basfar A., and Khalil M.I., Influences of Poly(vinyl alcohol) Molecular Weight and Carbon Nanotubes on Radiation Crosslinking Shape Memory Polymers, Prog. Nat. Sci.: Mater. Int., 2017.
11.Fei G., Li G., Wu L., and Xia H., A Spatially and Temporally Controlled Shape Memory Process for Electrically Conductive Polymer–Carbon Nanotube Composites, Soft Matter, 8, 5123-5126, 2012.
12.Pretsch T., Triple-Shape Properties of a Thermoresponsive Poly(ester urethane), Smart Mater. Struct., 19, 015006, 2009.
13.Behl M., Ridder U., Feng Y., Kelch S., and Lendlein A., Shape-Memory Capability of Binary Multiblock Copolymer Blends with Hard and Switching Domains Provided by Different Components, Soft Matter, 5, 676-684, 2009.
14.Keramati M., Ghasemi I., Karrabi M., Azizi H., and Sabzi M., Dispersion of Graphene Nanoplatelets in Poly(lactic acid) with the Aid of a Zwitterionic Surfactant: Evaluation of the Shape Memory Behavior, Polym.-Plast. Technol. Eng., 55, 1039-1047, 2016.
15.Sabzi M., Babaahmadi M., Samadi N., Mahdavinia G.R., Keramati M., and Nikfarjam N., Graphene Network Enabled High Speed Electrical Actuation of Shape Memory Nanocomposite Based on Poly(vinyl acetate), Polym. Int., 66, 665-671, 2016.
16.Babaahmadi M., Sabzi M., Mahdavinia G.R., and Keramati M., Preparation of Amorphous Nanocomposites with Quick Heat Triggered Shape Memory Behavior, Polymer, 112, 26-34, 2017.
17.Karimtehrani M., Ehsani Namin P., and Ghasemi I., Functionalization of Graphene Nanoplatelet and the Shape Memory Properties of Nanocomposite Based on Thermoplastic Elastomer Polyurethane/Poly(vinyl chloride)/Graphene Nanoplateletes, Iran. J. Polym. Sci. Technol. (Persian), 30, 287-297, 2017.
18.Haghayegh M., Mir Mohamad Sadeghi G., and Shamayeli B., Synthesis of Shape Memory Polyurethane/Nanoclay Composites: Chemical Structure and Interactions between Polymer and Nanoclay Particles, Iran. J. Polym. Sci. Technol. (Persian), 25, 19-30, 2012.
19.Zhang W., Chen L., and Zhang Y., Surprising Shape-Memory Effect of Polylactide Resulted from Toughening by Polyamide Elastomer, Polymer, 50, 1311-1315, 2009.
20.Zhang H., Chen Z., Zheng Z., Zhu X., and Wang H., Shape Memory Polymer Hybrids of SBS/dl-PLA and Their Shape Memory Effects, Mater. Chem. Phys., 137, 750-755, 2013.
21.Jing X., Mi H.Y., Peng X.F., and Turng L.S., The Morphology, Properties, and Shape Memory Behavior of Polylactic Acid/Thermoplastic Polyurethane Blends, Polym. Eng. Sci., 55, 70-80, 2015.
22.Gajria A.M., Dave V., Gross R.A., and McCarthy S.P., Miscibility and Biodegradability of Blends of Poly(lactic acid) and Poly(vinyl acetate), Polymer, 37, 437-444, 1996.
23.Wang H. and Qiu Z., Crystallization Kinetics and Morphology of Biodegradable Poly(l-lactic acid)/Graphene Oxide Nanocomposites: Influences of Graphene Oxide Loading and Crystallization Temperature, Thermochim. Acta, 527, 40-46, 2012.
24.Zhang H., Wang H., Zhong W., and Du Q., A Novel Type of Shape Memory Polymer Blend and the Shape Memory Mechanism, Polymer, 50, 1596-1601, 2009.
25.Wu X., Liu L., Fang W., Qiao C., and Li T., Effect of Hard Segment Architecture on Shape Memory Properties of Polycaprolactone-Based Polyurethane Containing Azobenzene, J. Mater. Sci., 51, 2727-2738, 2016.
26.Gu S.Y., Jin S.P., and Liu L.L., Polyurethane/Polyhedral Oligomeric Silsesquioxane Shape Memory Nanocomposites with Low Trigger Temperature and Quick Response, J. Polym. Res., 22, 142-148, 2015.
27.Chen Y., Chen K., Wang Y., and Xu C., Biobased Heat-triggered Shape-memory Polymers Based on Polylactide/Epoxidized Natural Rubber Blend System Fabricated via Peroxide-Induced Dynamic Nulcanization: Co-continuous Phase Structure, Shape Memory Behavior, and Interfacial Compatibilization, Ind. Eng. Chem. Res., 54, 8723-8731, 2015.
28.Gu S, Yan B, Liu L, and Ren J., Carbon Nanotube–Polyurethane Shape Memory Nanocomposites with Low Trigger Temperature, Eur. Polym. J., 49, 3867-3877, 2013.
29.Gunes, I.S. and Jana, S.C., Shape Memory Polymers and Their Nanocomposites: A Review of Science and Technology of New Multifunctional Materials, J. Nanosci. Nanotechnol., 8, 1616-1637, 2008.
Iranian Journal of Polymer Science and Technology
Volume 31, Issue 1 - Serial Number 153
March and April 2018
Pages 57-68

Files

Share

How to cite

Statistics