Molecular Dynamics Study on the Effect of Silicon Carbide Nanoparticles on Mechanical and Thermal Properties of an Araldite Epoxy Resin

Document Type : Research Paper

Authors

1 Department of Nuclear Engineering, Faculty of Engineering, Shahid Beheshti University, Postal Code 1983969411, Tehran, Iran

2 Department of Mechanical Engineering, Faculty of Engineering, North Tehran Branch, Islamic Azad University, Postal Code 1777613651, Tehran, Iran

Abstract

Hypothesis: Epoxy resins are thermoset polymers with extensive industrial applications. Their superior properties have attracted great attention in different fields. Having the potential to provide enhanced strength-to-weight and stiffness-to-weight ratios, reinforced polymers are superior to unreinforced ones. Using nanoparticles as reinforcement in a polymer can improve toughness, aging resistance, strength and fracture of the composites.
Methods: Molecular dynamics method was used to study the effects of silicon carbide (SiC) nanoparticles on the mechanical and thermal properties of the Araldite LY 5052/Aradur HY 5052 epoxy resin. Different simulation phases, including the minimization, equilibration, curing, and calculation of mechanical properties were carried out by NPT and NVT ensembles, based on the COMPASS II force field.
Findings: The simulation results indicated that the mechanical properties of the epoxy resin system at 300 K were not only in good agreement with other experimental and theoretical properties, but also they produced greater accuracy than the previous work by COMPASS force field. The results also indicated that the addition of SiC reinforcement to the epoxy resin system improved the mechanical properties such as strength and hardness as well as the thermal properties of the system while its density increased slightly. They showed that the optimum mechanical properties were related to low concentration of SiC nanoparticles. In epoxy resin with a higher nanoparticles percentage, by increasing the weight percentage, an agglomeration phenomenon occurred, porosity increased, and consequently the mechanical and thermal properties decreased. The effect of particle size on the mechanical and thermal properties of the epoxy resin system also showed that by increasing the particle size, the mechanical and thermal properties of the system were reduced. SiC nanoparticles with 3 different nanoparticle geometries were added to the epoxy resin system. The results showed that, due to a higher surface-to-volume ratio (0.6 1/cm), the epoxy resin system with the spherical reinforcement presented higher mechanical properties than the cylindrical (0.5 1/cm) and planar (0.26 1/cm) reinforcements.

Keywords

References

  1. Wanga Z., Lv Q., Chen S., Li C., Sun S., and Hu S., Glass Transition Investigations on Highly Crosslinked Epoxy Resins by Molecular Dynamics Simulations, J. Molecul. Simulat., 41, 37-41, 2015.
  2. Arab B. and Shokuhfar A., Molecular Dynamics Simulation of Cross-Linked Epoxy Polymers: The Effect of Force Field on the Estimation of Properties, J. Nano-Electron. Phys., 5,2013. DOI: org/10.1080/08927022.2014.998213
  3. Manjunatha G., Rajesh S., Raji G., and Kumara N., Influence of Post Heat Treatment Temperatures on Wear Properties of MWCNTs Reinforced Epoxy Composites, Am. J. Mater. Sci., 5, 183-187, 2015.
  4. Wang J., Xue Z., Li Y., Li G., Wang Y., Zhong W.H., and Yang X., Sergistically Effects of Copolymer and Core-Shell Particles for Toughening Epoxy, J. Polym., 140, 39-46, 2018.
  5. Park H., Kim B., Choi J., and Cho M., Influences of the Molecular Structures of Curing Agents on the Inelastic-Deformation Mechanisms in Highly Crosslinked Epoxy Polymers, J. Polym.,  136, 128-142, 2018.
  6. Hinkley J. and Clancy T., Molecular Modeling of Calculation of Mechanical Properties of Epoxies with Moisture Ingress, J. Polym., 50, 2736-2742, 2009.
  7. Company N., Available: http://www.nedform.com/magento/en/araldite-ly-5052-aradur-5052.html, 1999.
  8. Ge Z., Zhang W., Huang C., and Luo Y., Study on Epoxy Resin Toughened by Epoxidized Hydroxy-Terminated Polybutadiene, J. Mater. Sci., 11, 2018.
  9. Salehian H. and Jenabali Jahromi S.A., Effect of Titanium Dioxide Nanoparticles on Mechanical Properties of Vinyl Ester-Based Nanocomposites, J. Compos. Mater., 49, 2365-2373, 2014.
  10. Lin G., Xie G., Sui G., and Yang R., Hybrid of Nanoparticles with Carbon Fibers on the Mechanical and Wear Properties of Polymer Composites, Compos., Part B: Eng., 43, 44-49, 2012.
  11. Alian A.R., Kundalwal S.I., and Meguid S.A., Multiscale Modeling of Carbon Nanotube Epoxy Composites, J. Polym., 70, 149-160, 2015.
  12. Morshedian J., Abbassi-sourki F., Latifi M., and Maheri H., Polyolefin Elastomer Nanocomposites Reinforcements with Nanosilicon Carbide and Nanoclay Particles., Iran. J. Polym. Sci. Technol. (Persian), 31, 43-55, 2018.
  13. Soltani S., Naderi G., Ghoreishy M.H.R., Shokrzadeh A., and Razmjoo F., Mechanical and Morphological Properties of Short Nylon Fibers and Carbon Nanotubes Reinforced NR/SBR Nanocomposites, Iran. J. Polym. Sci. Technol. (Persian), 31, 345-357, 2018.
  14. Griebel M. and Hamaekers J., Molecular Dynamics Simulations of the Elastic Moduli of Polymer–Carbon Nanotube Composites, Comput. Method. Appl. Mech. Eng., 193, 1773-1788, 2004.
  15. Kochetov R., Andritsch T., Morshuis P.H.F., and Smit O.J., Thermal and Electrical Behaviour of Epoxy-Based Microcomposites Filled with Al2O3 and SiO2 Particles, IEEE International Symposium on Electrical Insulation, San Diego, USA, 6-9 June, 2010.
  16. Vahedi F., Shahverdi H.R., and Shokrieh M.M., and Esmkhani M., Effects of Carbon Nanotube Content on the Mechanical and Electrical Properties of Epoxy-Based Composites, New Carbon Mater., 29, 419-425, 2014.
  17. Lu C.T. and Weerasinghe A., Maroudas Dimitrios and Ramasubramaniam Ashwin., A Comparison of the Elastic Properties of Graphene- and Fullerene-Reinforced Polymer Composites: The Role of Filler Morphology and Size, Sci. Rep., 2016. DOI: 10.1038/srep31735
  18. Amal N. and Eman N., Study on Mechanical Properties of Epoxy Polymer Reinforced with NanoSiC Particles, J. Nanosci. Nanotechnol., 1, 89-93, 2013.
  19. Jeyranpour F., Alahyarizadeh G., and Minuchehr H., The Thermo-mechanical Properties Estimation of Fullerene-Reinforced Resin Epoxy Composites by Molecular Dynamics Simulation- A Comparative Study, J. Polym., 88, 9-18, 2016.
  20. Arash B., Wang Q., and Varadan V.K., Mechanical Properties of Carbon Nanotube/Polymer Composites, Sci. Rep., 4, 6479, 2014.
  21. Meller J., Molecular Dynamics, Encyclopedia of Life Science, 2001.
  22. Sun H., Jin Z., Yang C., Akkermans R.L., Robertson S.H., Spenley N.A., Miller S., and Todd S.M., COMPASS II: Extended Coverage for Polymer and Drug-Like Molecule Databases, J. Mol. Model, 2016. DOI:10.1007/s00894-016-2909-0
  23. Frigione M., Maffezzoli A., Finocchiaro P., and Failla S., Cure Kinetics and Properties of Epoxy Resins Containing a Phosphorous-Based Flame Retardant, Adv. Polym. Technol., 22, 329-342, 2003.
  24. Berrahou N., Mokaddem A., Doumi B., Hiadsi S., Beldjoudi N., and Boutaous A., Investigation by Molecular Dynamics Simulation of the Glass Transition Temperature and Elastic Properties of Amorphous Polymers PMMA, PMAAM and PMMA Co PMAAM Copolymers, Polym. Bull., 2017. DOI: 10.1007/s00289-016-1637-z
  25. Tack J.L., Thermodynamic and Mechanical Properties of EPON 862 with Curing Agent DETDA by Molecular Simulation, J. Mol. Graph. Model., 26, 1269-1275, 2008.
  26. Jeyranpour F., Simulation and Optimization of Carbon-Epoxy Composites by Molecular Dynamics for Nuclear Applications Huntsman, Shahid Beheshti University, Tehran, February 2016.
  27. Nasiri. Z. and Mashhady M., Investigation of Simultaneous Effect of Nano and Micron Silicon Carbide on Microstructural Properties and Mechanical Behaviour of Composite with Zirconium Diboride Matrix Reinforced by Aluminum Nitride, Malek-Ashtar University of Technology, Tehran, 2016.
  28. Mo Y., Zhang H., and Xu J., Molecular Dynamic Simulation of the Mechanical Properties of PI/SiO2 Nanocomposite Based on Materials Studio, J. Chem. Pharm. Res., 6, 1534-1539, 2014.
  29. Baharvandi.H., Nasiri.Z., Saeidi M., and Maheri H., Effect of Reinforced Particle Size and Temperature on the Microstructure and Mechanical Properties of Composite with Al-Al2O3 Matrix Produced by Vortex Casting, Malek-Ashtar University of Technology, Tehran, 2012.
  30. Cui W., Shen Z., Yang J., Wub S., and Baic M., Influence of Nanoparticle Properties on the Thermal Conductivity of Nanofluids by Molecular Dynamics Simulation, RSC Adv., 4, 55580, 2014.

 

Iranian Journal of Polymer Science and Technology
Volume 32, Issue 3 - Serial Number 161
September and October 2019
Pages 211-224

Files

Cited by

Share

How to cite

Statistics