Reinforcement of Bolted Timber Joints Using GFRP Sheets in Poplar and Pine Woods

Document Type : Research Paper

Authors

Abstract

Failure in timber structures occurs mainly in crucial points such as joints areas.
Therefore, the idea of using composite sheets in timber joints has been intro-
duced as a method in order to increase the strength and ductility behaviour of timber joints. This research aims to study the behaviour of bolted joints in poplar and pine woods, which are reinforced by two types of GFRP sheets. A single shear bolted joint consisted of 3 timber members whose length and width were 30 cm in length and 5 cm in width. The thickness of each member was 4 cm for internal part and 2 cm for external part. The employed steel bolt was 10 cm in length and 1 cm in diameter. In this respect, one layer of GFRP sheet was used to be bonded to timber members by using epoxy resin and left between the clamps for 24 hours. They were then kept at room temperature for three weeks. Also the effect of adding a wood veneer on the reinforced joints was investigated. The tensile strength of the reinforced and control samples (un-reinforced joints) was measured according to ASTM D5652-92 standard. The results show that the reinforced samples have higher tensile strength compared to that of reinforced joints, although it is not statistically signifcant. Also, two types of sheets infuence the joint behaviour as the reinforced joints display more ductility behaviour.

Keywords

Iranian Journal of Polymer Science and Technology
Volume 24, Issue 3 - Serial Number 3
September and October 2011
Pages 171-179

Files

Share

How to cite

Statistics